AEM: 22 Channel CAN Sensor Module

"Converts Analogue ,Frequency and Digital Channels to CAN Signals for Adding to CD Dashes"

AEM’s 22 Channel CAN Sensor Module converts analogue, digital and frequency inputs into an AEMnet CAN bus signal that can be transmitted to the CD-5 Carbon and CD-7 Digital Dashes. This module provides a way for users with carburetted vehicles to add a CD Digital Dash Display and lets users with existing CAN-based devices add more channels to the display for viewing and/or data logging (data logging requires CD-5L or CD-7L logging Dashes). See data logger in the Related Products tab.

The 22-Channel CAN Sensor Module is compatible with the CD Dashes only; it will run in parallel with 3rd party CAN devices on the CD dashes but it is currently not compatible with AEM’s AQ-1 Data Logger, Series 2 or Infinity ECUs, or 3rd party ECUs or loggers.
See downloads tab for the instruction manual.

WHAT YOU GET
The 22 Channel CAN Sensor Module includes four 0-5v analogue inputs, four Temp inputs, four user-configurable inputs for 0-5v, Temp (including RTD), a dedicated fuel level input, six configurable digital inputs or frequency-based inputs for switched or duty cycle, a Tach input and two VR inputs for crank, wheel or driveshaft speeds. A harness is included with pre-pinned, 36-inch colour-coded wires to connect inputs, and a DTM-style AEMnet cable to connect to a CD-5 or CD-7 Carbon Dash. Users can select the CAN speed delivery rate.



Features:
• Convert analogue, digital and frequency-based inputs to AEMnet CAN bus for display on CD-5 Carbon and CD-7 Dashes.
• Perfect for users with carburetted vehicles who want to add a CD Dash display
• Ideal for EFI users who want to add more channels to a CD Dash without purchasing multiple CAN-based devices
• Daisy chain two Modules together for additional channels
• IP65-rated enclosure is ‘dust tight’ and water resistant
• Wiring harness included with 36-inch flying leads and pre-wired CAN cable
• Four dedicated 0-5V Analogue inputs
• Four Temperature (thermistor) inputs
• Four user-configurable Analogue inputs, (jumper selectable; 0-5v, thermistor, or RTD)
• One dedicated Fuel Level input (0 to 250 ohm range)
• Six configurable Digital or Frequency inputs, active low, protected to ~18v, frequency, duty cycle or simple switch
• One Tach input, trigger when low, 12v internal Pull Up
• Two VR Pair Frequency inputs (crank, wheel or drive shaft speeds)
• Jumper selectable CAN bus speeds, 250k,500k,1M
• Jumper selectable terminating resistor
• Jumper selectable header length, 11bit or 29 bit
• Dimensions: 4.7” L x 4.3” W x 1.4” H (not including connector)
• Weight: 6.4oz / 180g

See Instruction manual in Download Tab.

Stock image used. Product may vary.